Fitting your new JAC M1 tested Rock and Roll bed
Included What you need
4 x Spreader plates 17mm spanner/socket
5 x M10x50 bolts Drill
5 x Nuts M10 drill bit
Silicone
2 Person assembly Metal paint
Please note
M10 bolts are supplied as standard. For altered or thicker floors, you may require longer bolts (not included)
The bed is designed to sit as far back in the van as possible to give more space while in the seated position.
-
Coat spreader plates with a metal paint such as Hammerite. The spreader plates are fitted to the underside of your van. We recommend that spreader plates are fitted to the four outer-most holes on the legs.
TIP
Legs on M1 tested beds are adjustable horizontally. If there is an obstruction on the underside of the van the legs can be loosened and adjusted accordingly to avoid the obstruction. Please ensure the bolts are sufficiently re-tightened after any adjustments.
If the bed is being fitted in a fixed position the legs do not need to be adjacent to each other. However, if bed is to be fitted to a tracking system, such as Unwin. The legs must be aligned.
​
2. Once the bed and legs are in the correct position, mark and drill pilot holes in the appropriate places. Once the bed is in a suitable position and the are no obstructions, drill the holes through the van floor using an M10 drill bit.
Two people require for the following steps.
3. Put a bead of silicone on the spreader plate to help make the plate watertight when connected to the underside of the van. The bolt and spreader plate can now be fitted through the underside of the van.
4. From inside the van you can now attach the nut to the bolt and tighten. Repeat until all spreader plates, nuts and bolts have been secured.
We recommend that the spreader plates are fitted to the underside of the van in the outermost holes.
Customers can use more bolts at their own discretion, but these are not required.
User guide for rock and roll bed
Bed position
Unlock front lock which is situated in the front centre of the frame
Release tension on the seatbelts
Pull front of seat towards you until bed is flat
Seated position
Locate the strap on the right-hand side of the bed
Position yourself at the front of the bed and pull the strap until the bed peaks
Push base back into a seated position until locking mechanism clicks and lock